Wireguard einrichten: Unterschied zwischen den Versionen
Zur Navigation springen
Zur Suche springen
K →Server |
|||
| Zeile 35: | Zeile 35: | ||
AllowedIPs = 10.0.5.2/32 | AllowedIPs = 10.0.5.2/32 | ||
</syntaxhighlight> | |||
<syntaxhighlight lang="bash" line="1"> | |||
echo "net.ipv4.ip_forward=1" >> /etc/sysctl.conf && sysctl -p && sysctl -w net.ipv4.ip_forward=1 | |||
</syntaxhighlight> | </syntaxhighlight> | ||
wg-quick up wg0 | wg-quick up wg0 | ||
Version vom 28. November 2024, 13:36 Uhr
Beschreibung
Download
Installation
apt install wireguard -y
Konfiguration
Server
Keys erzeugen
wg genkey | sudo tee /etc/wireguard/priv.key
chmod go= /etc/wireguard/priv.key
cat /etc/wireguard/priv.key | wg pubkey | sudo tee >> /etc/wireguard/pub.key
nano /etc/wireguard/wg0.confInhalt:
[Interface]
Address = 10.0.5.1/24
ListenPort = 51820
# Use your own private key, from /etc/wireguard/privatekey
PrivateKey = XXX
#Routen einstellen damit Clients kommunizieren können
PostUp = iptables -t nat -A POSTROUTING -o eth0 -j MASQUERADE; iptables -A FORWARD -i wg0 -o wg0 -j ACCEPT
PostDown = iptables -t nat -D POSTROUTING -o eth0 -j MASQUERADE
[Peer]
# Client 1
PublicKey = XXX
# VPN client's IP address in the VPN
AllowedIPs = 10.0.5.2/32echo "net.ipv4.ip_forward=1" >> /etc/sysctl.conf && sysctl -p && sysctl -w net.ipv4.ip_forward=1wg-quick up wg0
OPNSense als Client
Instanz erzeugen Peer erzeugen
Update
Test
Fehlerbehebung
Starten/Stoppen funktioniert nicht
Lösung 1
auszufüllen